| Saratoga Scents Soap Making Supplies 3D SOAP MOLDS - SOAP MAKING KITS - SOAP MAKING ESSENTIAL OILS - SOAP MAKING INSTRUCTIONS - SOAP MAKING OIL PROPERTIES |
 Home Apricot Kernel Oil Aroma Beads Arrowroot Powder Avocado Oil Babassu Oil Bath Bomb Kit Bath Bomb Recipes Bath Melt Base Bath Milk Base Bath Powder Kits Bath Oil Beads Beeswax Bentonite Clay Borax Castor Oil Castor Oil Red Cherry Kernel Oil Citric Acid Cocoa Butter Coconut Milk Coconut Oils Colloidal Oatmeal Cost Calculator Cottonseed Oil Dead Sea Salt Deodorant Base Diffuser Reeds Essential Oil Properties Emu Oil Emulsifying Wax Essential Oil Evening Primrose Oil Fairy Dust Kits Flax Seed Oil Fragrance Oil French Green Clay Glycerin Goat's Milk Recipe Grapeseed Oil Hazelnut Oil Hemp Oil Herbs INCI Names Jojoba Oil Kukui Nut Oil Lanolin Lip Balm Base Lotion Bar Base Lotion Making Kits Macadamia Nut Oil Making Incense Mango Butter Massage Oil Base Measurement Converter Mink Oil Moroccan Red Clay Neem Oil Palm Kernel Flakes Palm Oil Peach Kernel Oil Plastic Soap Molds 3D Soap Molds Potassium Hydroxide Rice Bran Oil Rice Flour Shea Butter Shea Oil Safflower Oil Saponification Chart Soap Cutters Soap Dishes Soapmaking Instructions Soap Making Kits Soapmaking Oil Properties Soapmaking Recipes Soap Paint Soap Planer Sodium Hydroxide Soybean Oil Stearic Acid Sunflower Oil Sweet Almond Oil Walnut Oil Wooden Soap Displays Wooden Soap Molds | 3D Soap MoldsOur 3D molds are a two-part mold designed specifically soap making, Melt & Pour or cold process and are manufactured from 0.060" thick, heavy duty clear PET plastic which will cast a double sided, three dimensional bar of soap, just like commercial store bought bars. Each two-part soap mold has an excellent chemical resistance, features a convenient built-in funnel to facilitate filling of the mold, and a precision channel, designed to align the two mold halves together, and eliminate leaking. Two Heavy Duty Rubber Bands are included with each two-part soap mold, which are used to hold the mold tightly together. Our 3D soap molds have been successfully tested in the oven at a temperature of 200°F for 1/2 hour without warping, but it is recommended to pour your soap at a tempature as low as possible, which will increase the mold's working life. Typical unmolding time for Melt & Pour soap is 4 hours and 24 hours or more for cold process soap. To un-mold the 3D soap, gently separate the two halves of the mold, until one half separates from the other. To un-mold the soap from the remaining half of the mold, gently bend the soap mold just a bit, this will break the seal with the soap, which will then release easily. You may even be able to get the soap to release by lifting it out by the extra left in the filling funnel channel, if there is any there. If you need to chill the mold to get the soap to release, place it in the freezer for approx. 15 minutes, or into the refrigerator for approximately 1 hour. Chilling the Melt & Pour glycerin within the molds will greatly aid in the release of the soap, but DO NOT let it freeze. For cold process soap, un-mold the soap using the same methods mentioned above. If the soap sticks to the mold, using a mold release may aid in the release of these types of soap. Rinsing the molds in warm water is all that is usually necessary to clean them after use. $6.00 Each
Contact | Conditions Of Use | 
|
